Cadence Skill check overlap DFA_bound_TOP/BOTTOM

tunghk1501 · 发表于 2023-3-31 12:21

EDA365欢迎您登录！

您需要登录才可以下载或查看，没有帐号？注册

x

本帖最后由 tunghk1501 于 2023-3-31 12:23 编辑

When placement done, run skill "check_daf_overlap.il" after show co-ordinates of overlap dfa_bound_top/bottom on command
After run Skill:
"C2505 "C2505" @182.5996:-100.4296 - "C2511" @180.1:-100.4 have overlapping geometry
"C516" @7.9996:-19.1296 - "C501" @9.9996:-21.6296 have overlapping geometry
"C3609" @150.8996:-23.4296 - "Q3600" @147.7:-21.4 have overlapping geometry
"C4510" @200.9996:-117.8586 - "R3104" @199.4:-116.7 have overlapping geometry
"C4510" @200.9996:-117.8586 - "R3105" @201.4:-116.7 have overlapping geometry
"C4606" @117.2996:-10.6296 - "L4600" @114.3996:-9.7296 have overlapping geometry
"C5400" @43.3:-63 - nil @38.25:-59 have overlapping geometry"C2505" @182.5996:-100.4296 - "C2511" @180.1:-100.4 have overlapping geometry
"C516" @7.9996:-19.1296 - "C501" @9.9996:-21.6296 have overlapping geometry
"C3609" @150.8996:-23.4296 - "Q3600" @147.7:-21.4 have overlapping geometry