Qusrtus2 11.0 时序仿真第1次出现错误

lvben5d

在QUARYUS2 ->TOOL->RUN EDA SIMULATION TOOL 后 运行ModelSim 6.5出现如下报错。希望高手指教。Q385157936
For example, ModelSim may display the following error message:
# ** Error: (vsim-19) Failed to access library 'work' at "work".
4 X) b$ v$ C6 V' l, R+ B7 q这个问题在网上收了下， 按照官网的说法如下：
To find the cause of and resolution to this error, use the following verror command at the ModelSim command prompt:verror 19;ModelSim returns the following message:# common Message # 19:
# The specified library could not be accessed at the specified location.
8 y/ e" a& s: E3 R0 E# Verify that the directory exists, that it contains the ModelSim library,
# and that you have the correct permissions for accessing it.
7 G. v& Z) u9 ?) j/ B# Also make sure that the _info file in the library has the correct
+ s8 I; D* `) |5 d& f# access permissions.
# This message might be followed by another message that gives more information
0 ~3 i, T' C3 |: A; c4 m# about the problem.
#
0 C' {  E3 B: D, e; K& o, r# The vlib command creates ModelSim libraries. The vmap command maps
" ~/ G$ m: Y; z3 ]) v0 A3 K# logical library names to physical library locations. Use the vmap
6 V4 R( O+ G+ c# {' T# command without arguments to find out how all of your libraries are
# mapped.
. J0 Q  u. j3 s" o# t! ]# i$ q: d#
# One way this problem can occur is if the mapping for the library in
6 M6 G- k6 u+ v7 Y& P, U# your modelsim.ini file contains an environment variable that is not set
# in your environment.还是不懂如何解决。

lvben5d

已经解决问题，大家注意，安装QUARTUS10.0版本后，路径千万不要带空格和中文！避免出现一些意外。