allegro导入网表警告问题

dabing88

因项目需求，需要设计一个tx2的地板，使用cadence orcad软件设计好原理图之后，生成网表成功。导出了英伟达公司的tx2的pcb封装，在allegro中导入网表的时候，出现以下警告，请问有大神能帮忙解答一下么
#3   WARNING(SPMHNI-192): Device/Symbol check warning detected. [help]
# l7 Y; f( w! X
WARNING(SPMHNI-194): Symbol '402' used by RefDes C18 for device 'C#1_402_0.1UF_10%' not found in PSMPATH or must be "dbdoctor"ed.

#4   WARNING(SPMHNI-192): Device/Symbol check warning detected. [help]
- k3 z. k* E; e' E/ L
WARNING(SPMHNI-194): Symbol '603' used by RefDes C37 for device 'C_603_0.1UF_10%' not found in PSMPATH or must be "dbdoctor"ed.
* Y/ O2 k) P/ |' y9 I" K
#5   WARNING(SPMHNI-192): Device/Symbol check warning detected. [help]

WARNING(SPMHNI-194): Symbol 'CON_DCPWR_JACK' used by RefDes J25 for device 'CON_PWR_JACK_CON_DCPWR_JACK_CON' not found in PSMPATH or must be "dbdoctor"ed.

#6   WARNING(SPMHNI-192): Device/Symbol check warning detected. [help]
. H3 F8 L  r: [( W  h: Y
6 p0 J( u, {% j, s% I0 O5 y' _WARNING(SPMHNI-194): Symbol 'MEC_HOLE_PTH' used by RefDes MEC3 for device 'MOUNTING_HOLE_MEC_HOLE_PTH_MOUN' not found in PSMPATH or must be "dbdoctor"ed.
+ c# P& ^. l3 s1 |: m' ]+ O
. `- ?* F- C- n  E  x7 z, s4 K% {+ y- f2 h

xueling2009

封装库要产生一个device文件，*.txt和一个PSM文件，*.psm，这样才能正确导入网表。

dzkcool

库里面没有这几个封装，看下是不是封装名不对，或者是没有psm文件

cxhhqz

xueling2009 发表于 2019-5-13 11:45
" |# v% u- l+ F# l封装库要产生一个device文件，*.txt和一个PSM文件，*.psm，这样才能正确导入网表。

. G1 _2 x2 n: @9 U: F- B! K+ i4 u用第一方网表的时候可以不用device文件

wu6886

good
" w' J. P, _0 G' [. g

xhl2733

学习