Derivative of state '1' in block 'A9yue12/PID Controller/Integrator' at time 0.0 is not finite. The simulation will be stopped. There may be a singularity in the solution. If not, try reducing the step size (either by reducing the fixed step size or by tightening the error tolerances)Component: Simulink | Category: Block error# J) m/ {5 y# G( ]
只要输入信号进到有积分项的模块中就会出现这个,是输入信号的问题？输入信号不能过零？1 M: W8 M f$ a7 `6 p4 _4 v* g; S
/1 
发表于 2020-10-12 13:38
收藏
淘帖
支持！
反对！