为什么part reference 属性下的名字不一样？？请高手解答

haifeng068

\请教高手，如下图
9 z% u3 Z8 y4 b5 |" G; U


  {/ H; e- k. N5 Q7 _

jacklee_47pn

你的問題跟 https://www.eda365.com/thread-45021-1-1.html 相同.
5 q- I! N( R% D! d可能是階層式繪製原理圖造成的.請參閱 https://www.eda365.com/thread-30786-1-1.html

haifeng068

回复 jacklee_47pn 的帖子
- C0 j" V( M7 @3 L& c8 E, `
" Q; H! E. `' t9 TThanks~
. O: H# r5 `5 P' E+ f$ q4 h A command in Capture menu Accessories-->Transfer Occ. Prop to Instance-->Push Occ. Prop into Instance
3 `$ h  o9 `, FWARNING: make sure you UNCHECK "Use this to remove all the Occurence properties from the design......".
After running this all my reference mismatch were resolved. I was able to copy parts or even whole page without problem.

5503892

不错，学习了。。。我从altium转过来也遇到这个问题，谢谢了