cr5000 v15.0 请教大神一个相同模块配置配线的问题！！！

wx_CX70Wp0t

cr5000 v15.0 这个功能怎么用啊？（相同模块配置配线用）12个相同的模块，为什么出来的情报中有的模块中器件没有按照规律排列？这个功能要和原理图联动？请大神帮忙！！跪谢！！
, \/ [, w0 x# N/ X- }
7 M0 y; ^- x1 m: A( X* A% W- Y; G1 o

wx_CX70Wp0t

没有大神吗？

chenxztiger

没有看到你12模块具体的情况，不好说。
! x, F2 S  D' e! U从你的图看，12个模块已经OK啦。其它的可能不符合条件，请参考Help：
2    The target components of copy destination must satisfy the following conditions:
5 U7 I" \2 b. Y4 e7 u
n     An unplaced component or off-board component

4 O4 p: b* {8 A! Ln     A component having the same part name as that of an original component
+ b; S0 f5 V6 x# V
n     A component having the same pin connection as that of an original component
/ W4 U1 Z+ s  Q
5 S3 l# Q+ R9 y' h+ o% Z9 P$ E2 N. Z) Mn     A component without position lock.

n     When a component is locked in angle, its angle is the same as that of the original one.

0 M& T5 }1 t5 m& m" Xn     When a component is locked in placement, its placement side is the same as that of the original one.
$ g. t) M/ J/ r% X
: F/ g' d* b  R+ [; d; V3    The original figures to be copied must satisfy the following conditions:
7 X8 P. b8 O2 l- T* s$ n% N8 p
n     A figure on the layer which is set to visible.
( g  v; k. o- D1 I. B/ Q9 F% \8 ?7 ?
, y9 X0 J$ ^: l3 i3 U: N( mn     A figure on the active layer when Reference Active Layer is set to on.

n     For vias, any layer among from-layer and to-layer of the via is the selected layer.
! H3 M& {3 q8 q# Z

FeniX0419

用日语版。。同学不错啊
5 V" t7 L+ ~3 n

weigz

谢谢分享

419549254

这个功能就是这样，有些识别不了，不是很好用

f3615669

日文看不懂吧

爱在纯真年代

简单的办法就是把要配置的模块部品移到板外，然后拷贝。每拷贝一次移一次。