走完线，铺铜后，铜不能显示，只是出现一个框， . l% X6 I+ r$ ^# } W B8 r$ I在status状态栏提示：( C4 a4 L* m% p+ |$ |9 H# ~
Layer = TOP ( ~# Z8 @7 t9 L ?$ p+ e8 N4 m$ b State: No Etch Point on shape: (-54.8472 -121.1691) Net: GND+ W# H8 L0 H8 P4 i$ X1 e' U" @7 {
用Edit---split plane铺铜后也是出现此框0 m# d2 _) S! D( c9 D. }
命令栏提示：1 S( x% u! ]3 o7 e, w2 v; ?
Shape moved from a null net to GND. - d1 Y: r# [1 r0 O: e/ M, ZClines previously connected to the shape will have to be resolved. 1 `7 B k- ~7 M$ W& v5 q请问该如何解决，急呀
/1 
发表于 2014-7-8 23:37
收藏
淘帖
支持！
反对！