|
|
% u2 z) A' n; W- ^* Y% L& u
不確定是不是這個問題造成的，但可以參考一下這些資料。
3 t2 t: F, b+ I& Y3 R- f8 o( E" W& u) \/ o- e, ^! U
下面這段話是肥死卡好（Freescale）的技術文檔節錄下來的，講得一針見血、但內容較雜（ 不只討論這個問題），我給你另一篇 ATMEL 的技術文檔，它專門討論 MCU 的 Start-up Time，淺顯易懂、還有一些電路上的建議！: _1 o5 Z0 ]- X2 j- ^7 i6 w
" v E* K }1 T6 ?3 D( g% m SLong Start-Up Time/ n6 o4 G4 J5 z' y$ w
A long start-up time is usually a more common problem with low-frequency crystals, since they tend to start much more slowly than high-frequency crystals. One of the causes of a long start-up time is weak loop gain. Oscillator start-up times will also be affected by the rise time of the power supply. When the power supply has a sharp rise time, the crystal will experience an energy impulse that will usually make it start faster than it would using a power supply with a slow rise time.9 a, j! o- x( f. Z5 A
# X$ C6 l. M. @8 I; x; V t 8 \5 o( i. v. E4 U, Q8 ?) m1 e) z
|
|
/1 
发表于 2015-6-24 20:29
收藏
淘帖
支持！
反对！
发表于 2015-6-25 09:36
楼主
发表于 2015-6-26 08:42