关于锁相环芯片的外部环路滤波电路的问题

一只小鱼儿

锁相环芯片的外部环路滤波电路接在了CPOUT管脚，手册上推荐该滤波电路需要靠近管脚放置，想请教一下，外部环路滤波电路如果不靠近CPOUT管脚放置，会有什么影响吗？

一只小鱼儿

超級狗 发表于 2024-9-23 12:50
踢哀（TI）E2E 論壇
As for the CPout pin, this is the charge pump output which can range from 0 to 2 ...

感谢，刚看TI的资料，这应该会对相位噪声有点影响。
3 r( L/ T( _6 c

超級狗

踢哀（TI）E2E 論壇
As for the CPout pin, this is the charge pump output which can range from 0 to 2.5V, as it is powered by a 2.5V regulator. If this voltage falls below 0.5 V or goes above 2.0 V, then the Vtune lock detect will consider this unlocked. When the VCO is calibrated, this targes a voltage of around 1.2 volts, but this voltage can "tune" to adjust the VCO frequency.

' y, [: i8 I( Z

超級狗

6 ^3 N, _6 u) Y2 K  @- W
CPOUT
Charge-Pump Output. Connect a PLL loop filter as a shunt C and a shunt combination of series R and C.

- q/ ^5 T$ k% u) g2 d* s7 P