如何写时钟模块才比较规范合理，大侠给个标准模板吧

mengzhuhao · 发表于 2008-5-7 18:32

EDA365欢迎您登录！

您需要登录才可以下载或查看，没有帐号？注册

x

如何写时钟模块才比较规范合理，大侠给个标准模板吧

`timescale 10ns / 1ns
module clktest(
clk,
reset,
datain,
dataout);
input clk;
input reset;
input [3:0]datain;
output[3:0]dataout;
wire clk;
wire reset;
wire clkout1;
wire clkout2;
wire clkout11;
wire clkout22;
clkgen clkgen(clk,reset,clkout1,clkout2);
datain_dataout datain_dataout(clkout1,clkout2,reset,datain,dataout);
endmodule
/////////////////////////////////////////////////////////////////
module clkgen(clk,reset,clkout1,clkout2);
input clk;
input reset;
output clkout1;
output clkout2;
reg [3:0]cnt;
reg clkout11;
reg clkout22;
assign clkout1=!clkout11;
assign clkout2=!clkout22;

always @(posedge clk)begin
if(!reset)
cnt<=0;
else
cnt<=cnt+1;
  end
always @(posedge clk)
  begin
clkout11=~cnt[2];
clkout22=~cnt[3];
end
endmodule
////////////////////////////////////////////////////////
module datain_dataout(clkout1,clkout2,reset,datain,dataout);
input clkout1;
input clkout2;
input reset;
input [3:0]datain;
output [3:0]dataout;
reg [3:0]datatemp;
reg [3:0]dataout;
reg [3:0]cntt;
always @(posedge clkout2)begin
if(!reset)
cntt<=0;
else
cntt<=cntt+1;
  end

always @(posedge clkout1)begin
if(!reset)
datatemp<=0;
else
datatemp<=datain;
  end
always @(posedge clkout1)begin
if(!reset)
dataout<=0;
else
dataout<=datatemp;
  end

endmodule
////////////////////////////////////////////////
提示下面的警告：
clkgen.v(14): clock signal should not be driven (gated) by inverted logic (clock: "clkout1" (datain_dataout.v(28)); inverted logic output: "clkout1")

clkgen.v(14): clock signal should not be driven by logic which is not in clock_gen module (clock: "clkout1" (datain_dataout.v(22)); driving logic output: "clkout1")

clkgen.v(25): BLOCKING assignment should not be used in an edge triggered block

帐号		自动登录	找回密码
密码			注册

如何写时钟模块才比较规范合理，大侠给个标准模板吧

EDA365欢迎您登录！

浏览过的版块

推荐内容 /1