|
|
EDA365欢迎您登录！
您需要 登录 才可以下载或查看，没有帐号？注册
x
生成光绘后，如下信息，请问，这些warning有没有影响，谢谢。
4 w( ^9 f; R$ N- F# z
& |) ~0 v' _% P5 B' x, c================================================================; b3 p# r1 m z" N* u4 E
PROCESSING FILM < TOP >/ ?/ S0 F: m7 t: j3 V4 W" E
TO FILE < D:/SCWORK/SYSB/PCB/TOP.art > ...
' H; h- E0 N. U, s3 {; i* P" M================================================================
* R% G9 g, l& J) j3 \8 y p8 K# h. x
) I8 Z& W0 Q" A* L$ Q* N FILM PARAMETERS :
; d6 f! \5 i: B" R2 E5 E ---------------------------------------------------------
0 o/ ?' b3 c* B; w Undefined line width 6.000; _3 t, E ?% M/ L. a" M
Mirror code NONE
5 e: {' o' p3 A! e Rotate angle NONE
, D$ G( V) k# S( ^ Offset x: 0.000
4 G) x6 @4 ^! h3 [ Offset y: 0.000& F! }8 M/ L+ [% N: H
Plot negative NO3 e$ @) i$ d$ D* c. K
Suppress unconnected internal pads NO6 O( y* `/ ]& W7 V1 l" m8 O; }2 q, ?. ]
8 ?) y1 c: ]* p7 x) L
WARNING: 0 width line found at (20.000 0.000)
2 Y: X2 E) t5 j# V% b! j7 x; Z% M* u ... using undefined line width of 6.000
; Z& S9 j5 h$ |. K |6 Q8 t0 z6 O m/ C% t8 y
WARNING: Segment with same start and end points at0 X- q) H- h. W+ w
(2709.189 1745.260) will be ignored. Increasing output
; X* k G4 D, j/ b: K2 R accuracy may allow segment to be generated.( Y3 @8 _/ a- t- p* O2 c
9 U* I" t- o; x$ |- c f& r' L x
WARNING: Segment with same start and end points at$ s) z, ?4 O7 i. w, F; X8 V6 U
(1175.500 1103.598) will be ignored. Increasing output+ ~; D; `) F) \3 Y/ s( D- U2 {
accuracy may allow segment to be generated. |
|
/1 
发表于 2013-12-5 15:03
收藏
淘帖
支持！
反对！
楼主
