灌铜时出现如下提示，怎么改？

zxinli · 发表于 2009-4-16 19:44

EDA365欢迎您登录！

您需要登录才可以下载或查看，没有帐号？注册

x

如题：

   Drilled pads with                   Nondrilled pads with
less than 50% thermal extensions    less than 50% thermal extensions
Report of Thermal Spokes Generator.
On Bottom:
                                    C151.2  (-121.23, 6795.7) # = 1
                                    U38.3 (657.87, 6853.54) # = 0
                                    C35.2 (1812.02, 3747.48) # = 1
                                    U8.13 (2640, 4440.77) # = 1
                                    U35.36  (308.35, 5110.45) # = 1
                                    U27.9 (1126.28, 4996.87) # = 0
                                    C114.2  (-511.46, 2505.14) # = 0
虽然知道这个没什么太大影响，    但我没遇到过，请教各位大虾，是我哪里设置的不够？
谢谢！

jimmy · 发表于 2009-4-16 22:28

如题：; Y* A8 a/ M1 \& G8 a
  ! i5 p( I0 Q9 T: _: |0 O7 V
   Drilled pads with                   Nondrilled pads with4 j! s# U5 Y6 S+ C4 }9 h) B. Y
less than 50% thermal extensions    less than 50% thermal extensions
5 D; S: c1 F. f: L% L; D3 _5 w  \Report of Thermal Spokes Generator.! V" w5 `6 v: d/ X
On Bottom:2 s4 Z  m0 R! Z6 n  R4 r+ `
  ...
( p' V* q# ^2 \2 @; Izxinli 发表于 2009-4-16 19:44