|
|
2 _' k) S3 U+ s v不確定是不是這個問題造成的，但可以參考一下這些資料。
- X8 F( |1 x7 \, I/ T
, m7 s6 x0 |5 c, \2 m% Q- D下面這段話是肥死卡好（Freescale）的技術文檔節錄下來的，講得一針見血、但內容較雜（ 不只討論這個問題），我給你另一篇 ATMEL 的技術文檔，它專門討論 MCU 的 Start-up Time，淺顯易懂、還有一些電路上的建議！
* t z3 V% m. f5 ~, V1 G% K, Z$ v1 l1 t0 ?
Long Start-Up Time* g8 `9 e0 C$ p# u
A long start-up time is usually a more common problem with low-frequency crystals, since they tend to start much more slowly than high-frequency crystals. One of the causes of a long start-up time is weak loop gain. Oscillator start-up times will also be affected by the rise time of the power supply. When the power supply has a sharp rise time, the crystal will experience an energy impulse that will usually make it start faster than it would using a power supply with a slow rise time.' q7 Z/ ?4 w2 z6 e7 B% d9 w9 L
1 x) |+ \/ U& e% t1 J" j9 |
 & [( B% q4 ?7 x5 m- n6 k ^
|
|
/1 
发表于 2015-6-24 20:29
收藏
淘帖
支持！
反对！
发表于 2015-6-25 09:36
楼主
发表于 2015-6-26 08:42