标题: allegro导入网表警告问题 [打印本页] 作者: dabing88 时间: 2019-5-13 11:23 标题: allegro导入网表警告问题 因项目需求，需要设计一个tx2的地板，使用Cadence orcad软件设计好原理图之后，生成网表成功。导出了英伟达公司的tx2的pcb封装，在allegro中导入网表的时候，出现以下警告，请问有大神能帮忙解答一下么 * P1 Z& ~0 p9 [$ r0 {#3 WARNING(SPMHNI-192): Device/Symbol check warning detected. [help] * k& ^: D @( v2 J & o2 q' I0 V6 m: F7 M# e6 p( \5 IWARNING(SPMHNI-194): Symbol '402' used by RefDes C18 for device 'C#1_402_0.1UF_10%' not found in PSMPATH or must be "dbdoctor"ed. : V- W& x$ Q2 J4 D" ^' j- s. c 4 o+ }* |1 C4 |2 [#4 WARNING(SPMHNI-192): Device/Symbol check warning detected. [help] " l' K9 e5 G# o n% i3 q7 } }: @" b2 ~; L
WARNING(SPMHNI-194): Symbol '603' used by RefDes C37 for device 'C_603_0.1UF_10%' not found in PSMPATH or must be "dbdoctor"ed.# [) E( J# `$ B" \
$ I" j4 Z/ C3 \2 \: f& ~( g7 f
#5 WARNING(SPMHNI-192): Device/Symbol check warning detected. [help]5 C4 p8 V. `( {
% Y. l' b% c7 uWARNING(SPMHNI-194): Symbol 'CON_DCPWR_JACK' used by RefDes J25 for device 'CON_PWR_JACK_CON_DCPWR_JACK_CON' not found in PSMPATH or must be "dbdoctor"ed. W/ A) r# D3 e, [: C, O B+ ~5 |' S" R9 l9 g4 ^#6 WARNING(SPMHNI-192): Device/Symbol check warning detected. [help]% N& P# c* Y+ m1 Q6 Z F, X2 M
Q' j. ~/ m: A3 f3 wWARNING(SPMHNI-194): Symbol 'MEC_HOLE_PTH' used by RefDes MEC3 for device 'MOUNTING_HOLE_MEC_HOLE_PTH_MOUN' not found in PSMPATH or must be "dbdoctor"ed." n8 h$ F9 V& i5 W( y) o: a. [% q' i6 i
, o# E" g; ?" Z* k8 O7 F. C 作者: xueling2009 时间: 2019-5-13 11:45
封装库要产生一个device文件，*.txt和一个PSM文件，*.psm，这样才能正确导入网表。作者: dzkcool 时间: 2019-5-13 13:19
库里面没有这几个封装，看下是不是封装名不对，或者是没有psm文件作者: cxhhqz 时间: 2019-5-13 14:13